Plastic humidifier shell mold processing

Plastic humidifier shell mold processingMold processing equipment must be checked carefully before use1. Before the mold processing equipment starts to work, we should check whether there is any probl

  • 型号:
  • 型号: Plastic humidifier shell mold processing

Plastic humidifier shell mold processing

Plastic humidifier shell mold processing


Mold processing equipment must be checked carefully before use








1. Before the mold processing equipment starts to work, we should check whether there is any problem in each part, whether the clutch and brake equipment are normal, whether there is lubricating oil in the gear part, when the inspection is completed, turn on the machine tool and run it for about 3 minutes, if not Exceptions can be put into use.




2. When all workers enter the work area, they should check their clothes to see if they meet the requirements. Do not wear slippers, high heels, and clothing that affects work. Maintain the correct posture, and have sufficient psychological response when working. If you feel uncomfortable, you should leave your job immediately and report to your superiors. In our actions, we must concentrate, avoid empty talk, and cooperate with each other. Operators should not be in anxious and fatigued state to avoid accidents and ensure safe operation.




3. When the equipment starts to work, other personnel should leave the work area and ensure that other debris will not interfere with the normal operation of the equipment.




4. When working, the idle power should be turned off, and finished products and finished products should be organized to ensure a clean and safe working environment.




5. During the transportation of machinery and equipment or materials, all personnel are not allowed to touch the switch privately; when the equipment starts to work, it is forbidden to touch the working area with hands to avoid accidents; when the machine produces abnormal noises, immediately Shutdown inspection.




6. When changing the mold, turn off the power, stop the operation, and then start to install and debug the mold. After installation and adjustment, move the flywheel twice to check whether the upper and lower molds are symmetrical and reasonable, whether the thread is firm, and whether the position of the blank holder is reasonable.