Electricity testing equipment plastic mold

Electricity testing equipment plastic mold

Is the injection mold simple? That's just what you see on the surface

Everyone thinks that the structure of an injection mold is very simple, because everyone only sees the surface, but they don’t know that a design is designed to design a mold, but it takes several days to draw a 3D picture and then convert it into a 2D picture. time. During this period, the designer has to go through a lot of tests and judgments when designing each ejector, otherwise it will cause the ejector to be misaligned.

In fact, designers will think of a plan before designing the analysis of the injection mold structure, but there will be two plans in it. The research of the plan can be complementary, and there are not many designers that can truly be 100% okay.

However, during the injection mold process, attention needs to be paid to the interaction between the overall mold base and the mold core, otherwise there will be misalignment, causing mold problems; also pay attention to hot runner design problems, if there is a problem, it will cause the mold production process In the case of shrinkage, the produced mold is still unreasonable, so injection molds need to pay attention to these issues.

However, the three points that must be paid attention to in the structure of the injection mold are the coordination of the entire mold base and the mold core, otherwise there will be a problem of misalignment.